Nitrous Express DRAG-Pro N2O - Manual (Page 22)

21
Davis Technologies TM-4000-Drag-PRO V3 n
2
0 2010
3. Turn the power On
4. While holding the “Test” button down, move
the dial to the desired buffer value.
5. Release the “Test” button,
The led will flash to show the value that the buffer is
now set to. Valid settings are 0-3.
(Buffer 2= 2 blinks)
(zeros are indicated by shorter blinks)
Sample Rate:
( default= 3)
The Sample Rate can be set to change the sensitivity
of the unit. This should only be changed under the
advice of tech support. Valid settings are 1-5. To
change the value, follow these steps.
1. Set the “Mode” dial to “2”
2. Hold down the “Test” button
3. Turn the power On
4. While holding the “Test” button down, move
the dial to the desired Sample Rate value.
5. Release the “Test” button,
The LED will flash to show the value that the Sample
Rate is now set to. Valid settings are 1-5.
(Most users never need to adjust the Sample Rate)