Nitrous Express DRAG-Pro N2O - Manual (Page 17)

16
Davis Technologies TM-4000-Drag-PRO V3 n
2
0 2010
2. Hold down the “Test” button
3. Turn the power On
4. While holding the “Test” button down, move
the “Mode” dial to the first digit of the desired
Starting RPM.
(example- 1500rpm - first digit=1 / 3000rpm - first digit =3)
5. Release the “Test” button,
The led will flash to show the value has been
accepted.
6. Now move the “Mode” dial to the second digit
of the desired Starting RPM, then press and release
the “Test” button.
(example- 1500rpm - sec. digit=5 / 3000rpm -
sec. digit =0)
The led will flash to show the value has been
accepted.
After about 1 second the LED will Blink to show the
value that the Starting RPM is set to. The first digit
is output followed by a short pause, then the second
digit is output.
(1500 RPM = 1,5 Blinks) (zeros are
indicated by shorter blinks)
Ending RPM:
(default (99 ) 9900 Rpm)
The driveline RPM at which the unit Stops to make
corrections can be set by the user. Some users may
want the unit to stop at a certain RPM while others
may want the unit to be able to make corrections for
the entire run. Once set the value will remain until