Nitrous Express DRAG-Pro N2O - Manual (Page 19)

18
Davis Technologies TM-4000-Drag-PRO V3 n
2
0 2010
Null Mode:
( default= 0)
The Null Mode sets how the Traction Control will
make corrections in the Null Zone. To set the Null
Mode, follow these steps.
1. Set the “Mode” dial to “6”
2. Hold down the “Test” button
3. Turn the power On
4. While holding the “Test” button down, move
the “Mode” dial to the desired Null Mode value.
5. Release the “Test” button,
The led will flash to show the value that the Null Mode
is now set to. Valid settings are 0-2.
(Null Mode 0- Traction Control makes corrections in the normal manor.
Null Mode 1- Traction Control only makes Step 1(small) corrections.
Null Mode 2- T/C will not make any corrections within the set range.)
Null Low RPM:
(default (40 ) 4000 Rpm)
The low RPM of the zone at which the unit Begins to
make corrections. Once set the value will remain
until changed by the user. The RPM is set in 100
rpm increments, (example 4000 rpm, divided by 100=
40). To change the Null Low RPM value, follow
these steps.
1. Set the “Mode” dial to “7”
2. Hold down the “Test” button