Nitrous Express DRAG-Pro N2O - Manual (Page 20)

19
Davis Technologies TM-4000-Drag-PRO V3 n
2
0 2010
3. Turn the power On
4. While holding the “Test” button down, move
the “Mode” dial to the first digit of the desired Null
Low RPM.
(example- 4000rpm - first digit=4 / 3500rpm - first digit =3)
5. Release the “Test” button,
The led will flash to show the value has been
accepted.
6. Now move the “Mode” dial to the second digit
of the desired Null Low RPM, then press and release
the “Test” button.
(example- 4000rpm - sec. digit=0 / 3500rpm -
sec. digit =5)
The led will flash to show the value has been
accepted.
After about 1 second the LED will Blink to show the
value that the Null Low RPM is set to. The first digit
is output followed by a short pause, then the second
digit is output.
(4000 RPM = 4,0 Blinks) (zeros are
indicated by shorter blinks)
Null High RPM:
(default (60 ) 6000 Rpm)
The high RPM of the zone at which the unit Stops
making corrections. Once set the value will remain
until changed by the user. The RPM is set in 100
rpm increments, (example 6000 rpm, divided by 100=
60). To change the Null High RPM value, follow
these steps.
1. Set the “Mode” dial to “8”