Nitrous Express DRAG-Pro N2O - Manual (Page 13)

12
Davis Technologies TM-4000-Drag-PRO V3 n
2
0 2010
than zero. This method simply looks for a threshold
of acceleration change to be exceeded and the
outputs will be triggered. The higher the number the
more sensitive the system is. A good starting point
is 4. Valid settings for threshold are 1-9. (When
using this method the Mode setting has no effect on the
system, with the exception of Mode 0, or Mode 9).
Starting RPM is a user adjustable setting that allows
the racer to set the point at which the unit begins
making corrections. If the Starting RPM is set to
1800 RPM, then the unit is active and monitoring the
driveline, but not making any corrections until the
Starting RPM is reached. This may be useful to
prevent the Traction Control from interfering with an
already established launch setup.
Ending RPM is a user adjustable setting that allows
the racer to set the point at which the unit Stops
making corrections. If the Ending RPM is set to
5800 RPM, then the unit is active and monitoring the
driveline, but not making any corrections after the
Ending RPM is reached. This may be useful to
prevent the Traction Control from making
corrections Down Track if desired.
(This may be useful
on tracks w/ bumps or conditions that may cause tire slip, but a
loss of HP may be undesirable)
The Null Zone is a feature that allows the user to
modify how the Traction Control reacts at certain
RPM’s. The user can set an RPM zone in which the
Traction Control will make no corrections, or level 1
(small)
corrections only. There are three
components to this feature. The Null Mode sets the
unit to either react as normal or to limit the type of