Lokar Tuned-Port Hi-Tech Kickdown - Manual

Step 1: Install the billet aluminum throttle bracket assembly to
the tuned-port unit as shown in Fig. 1.
Step 2: Install trans tube into trans without o-ring and inner
cable, and then install adjuster into the Lokar Billet
Aluminum Throttle Bracket as shown in
Fig. 1.
Step 3: Route braided cable housing up to adjuster, add
1" extra length and cut outer housing to desired length.
Step 4: Remove and re-install trans tube with inner cable and
o-ring in place. To insure against leakage add a small
amount of silicone (sealant) around the trans tube above
top o-ring.
Fig. 2
Step 5: Snap the plastic Lokar slide fitting on the tuned-port.
Step 6: Install inner cable through Lokar Cable Slide Fitting
and slide cable stop over cable. Position cable stop
approximately 1 1/2" from hex fitting and tighten
allen set screw. Cut off excess cable leaving about 1"
extending beyond cable stop.
Step 7: Make final adjustments by holding throttle to wide
open and pulling the kickdown inner cable as tight as
possible. Slide cable stop up against Lokar Cable Slide
Fitting and tighten allen set screw. When the kickdown
is properly adjusted you should be able to open the
throttle to wide open position and there should be no
slack in the kickdown cable.
Tuned-Port Hi-Tech Kickdown Installation Instructions
Building American Quality… With A Lifetime Warranty!
General Installation Notes:
Please read instructions completely before beginning
installation. If you have any questions please don’t
hesitate to call.
Do not attempt to install or adjust Throttle Cable or
Kickdown kit while engine is running. Be sure engine,
body and frame are grounded properly.
We recommend using an anti-seize lubricant on all
aluminum threads before installation. Do not over tighten
while fitting cables.
Cut housing by using diagonal cutters, Lineman pliers
or taping the housing and using a fine-tooth hacksaw.
Klein diagonal cutters, part no. D2000-28 (available at
Grainger’s, part no. 4A838) work best.
Kickdown hook-up
O-Ring
Trans Tube
Kickdown Installation
Note: The kickdown kit is designed to mount to our Tuned-
Port Billet Aluminum Throttle Bracket. Do not remove
braided housing from transmission tube.
Fig. 1
Fig. 2
Step 8: Double check to be sure that all carb and throttle
linkage operates freely without binding, then test
drive. Once kickdown is correctly adjusted and
operating properly you can cut off the excess
cable beyond the cable stop.
TH-350, 200-4R, 700-R4, 4L60
Tuned-Port Hi-Tech Kickdown Installation Instructions
TH-350, 200-4R, 700-R4, 4L60
10924 Murdock Dr. • Knoxville, TN 37932
TOLL FREE 1-877-469-7440 • (865) 966-2269 • FAX (865) 671-1999 • [email protected] • www.lokar.com
© 2008 Lokar, Inc. Rev. 04/21/08 - RPD 07/14/09
®