Lokar Competitor Series Throttle Assembly User Manual

Photos 1 - 5

Building American Quality… With A Lifetime Warranty!

(Step 3 cont.)
The tension is pre set from Lokar
and locked into place with a set-
screw and Loctite

. It is not neces-

sary to remove this tension nut. Pull
the pedal arms out of the cradle.
Use the mounting base of the pedal
assembly to transfer punch the two
mounting holes onto the firewall.

Photo 3

Drill two 1/4" thru holes for the pedal
to mount. The pedal base is drilled
and tapped 1/4–20 thread.

Step 4: Adjust the pedal arms to the desired

angles.

Photo 4 Reassemble the

throttle pedal. Install the axle through
the upper and lower arms and slide it
back into the tension nut. Screw the
flat head screw and trim washer on
the right side and tighten. Check the
throttle pedal and make sure that the
pedal is

NOT binding.

Step 5: The upper arm will need to be pushed

up against the firewall. There will
need to be a 5/16 thru hole drilled in
the firewall in line with the hole in the
upper pedal arm. This is for the Lokar
throttle cable fitting to mount.

Photo 5

NOTe: Adjust the throttle pedal until the
pedal touches the floor at the same time
the throttle reaches wide open position.
This will assure that you will not over
pull the throttle.

Step 6: Install Lokar throttle cable assembly

per instructions supplied with
throttle cable.

Stop! Read all installation instructions before begin-

ning installation. Please call Lokar with any questions

or uncertainties that may arise during the installation.

WARNING: Disconnect the battery before beginning

installation. Make sure the vehicle is in Park and at

least one tire is scotched to prevent the vehicle from

moving.

IMpoRtANt AppLICAtIoN INFoRMAtIoN:

The Lokar pedal assembly is designed for Lokar

Throttle Cables. Stock style cables will not work. If

the application has an automatic transmission, please

purchase the appropriate kickdown kit to complete

the installation. The cables and mounting brackets

must be ordered for specific applications; i.e.,

carbureted, tuned-port, EFI, blower, etc.

Competitor Series Throttle Assembly Installation

Step 1: Remove any existing throttle pedal and all throttle

linkage or cables.

Step 2: Choose the location where the Lokar throttle

assembly will be mounted.

Step 3: Disassemble the Lokar billet throttle pedal

assembly by removing the 10-32 x 1/2" stain-
less flat head cap screw on the right side of the
pedal assembly.

Photo 1 Pull the axle out of the

cradle and pedal assembly.

Photo 2 There is an

adjustable tension nut that is threaded into the
aluminum housing. This nut is to set the side to
side tension on the pedal assembly.

10924 Murdock Dr. • Knoxville, TN 37932

TOLL FREE 1-877-469-7440 • (865) 966-2269 • FAX (865) 671-1999 • [email protected] • www.lokar.com

Competitor Series Throttle Assembly Installation

Competitor Series Throttle Assembly Installation Instructions

Photos 1 - 5

Photo 1

Photo 2

Photo 3

Photo 4

Photo 5

Rev. 02/02/11

™

Part # BAG-6148, XBAG-6148, BAG-6149, XBAG-6149

™