Lokar XEFB-9003 Under-the-Dash Foot Operated Emergency Brake User Manual

Page 2

Step 3: After drilling and mounting firewall, mount

slider bracket to firewall or side structure, bolt
E-brake assembly to firewall mount slider brack-
et and slide into desired location. Now install
the front slider bracket to the main frame in
order to locate the dash mounting bracket. The
dash mounting bracket has a curved slot in it to
allow for many different dash angles. The dash
mounting bracket comes with three mounting
holes for mounting to the back of the dash.
However, one mounting bolt to the dash is suf-
ficient. When looking at the footbrake assembly
from the driver’s position, the right hand dash
mounting bracket hole can also be used to
mount the release rod mounting bracket. Two
1/4-28 x 5/8" allen bolts and nylocks are pro-
vided to mount the dash mounting bracket and
the release rod mounting bracket.

Step 4: Once dash mounting bracket and firewall mount

slider bracket have been mounted and main
frame is in position, the L-shaped release rod
can be cut-to-fit. Slip the footbrake release
knob through the release rod mounting bracket,
install release rod spring, and adjust nut up
just enough to take the slack out and put some
tension on the release rod spring. Release rod
spring must not be loose. Line up release rod
level with footbrake release knob and mark and
cut with a hack saw.

Under-the-Dash Foot Operated Emergency Brake Instructions

Building American Quality… With A Lifetime Warranty!

Under-the-Dash Foot Operated Emergency Brake Instructions

Part # EFB-9000 through EFB-9009, XEFB-9001 and XEFB-9003

Main frame with
cover removed
showing connector
cable installation

10924 Murdock Dr. • Knoxville, TN 37932

TOLL FREE 1-877-469-7440 • (865) 966-2269 • FAX (865) 671-1999 • [email protected] • www.lokar.com

Step 5: Before final installation of release rod, remove main

frame assembly from mounting brackets and remove
main frame cover. Now install Lokar Connector Cable,
(Part No. EC-8001U Black housing or EC-8001HT
Stainless housing; Not included with footbrake kit.)
NOTE: Housing of brake cable must be cut to length
before inner wire installed. Once cable is installed,
replace main frame cover. Assemble using the
5/16-24 nylock nuts and dispose of the non-locking
nuts. Do not over tighten assembly. Over tightening
can distort assembly and bind pedal. Run connector
cable under vehicle and install Lokar emergency brake
cables to rear brakes. To look up the correct part
number for your application, check www.lokar.com.
To place an order, call toll free 1-877-469-7440 or
call your nearest dealer.

Rev. 3/5/07

This manual is related to the following products:

XEFB-9001 Under-the-Dash Foot Operated Emergency Brake EFB-9000 through EFB-9009 Under-the-Dash Foot Operated Emergency Brake