ididit Retrofit Steering Column: 1962-66 Nova - Manual (Page 11)

9
Turn Signal Lever:
A screw is provided with the Dress-up
kit. This screw will secure the turn signal
lever to the column. PLEASE NOTE
there are two holes on the turn signal
switch. One D shaped and the other
is round. The screw is to be inserted
in the round hole! Use a #2 Phillips
screw driver to tighten this screw tightly.
It holds the lever and the switch half’s
together. (Figure 11)
Emergency Flasher Knob:
The Emergency flasher is threaded into
the hole located on the right side of the
column. You will noticed the plastic portion
that the flasher screws into is flush with the
outer surface when the flashers are in the
off position. It is easy to accidently turn the
flashers ON while installing which could
lead to problems later. Check to make sure
the flashers are in the OFF position before continuing.
(Figure 12)
Hook the battery back up & continue with the last steps of
this installation.
OEM wiring w/Flasher Kit:
Test the turn signals:
1. Push brake pedal, brake lights should come on.
2. Push 4-way flasher in and verify that the interior indicators and
exterior flashers are flashing properly.
3. Turn key to on position.
4. Check both left and right turn signals and indicators.
(Figure 11)
(Figure 12)