ididit Golf Cart Steering Column: Golf Cart 9-Bolt Steering Wheel Adaptor - Manual

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
Golf Cart 9-Bolt Adaptor Installation Instructions
For Part Number’s 2211200040, 2211400040, 2211600040
Instruction #: 8000010030 REV 12/12
1. Remove clip/score board from steering wheel
(Figure 1)
a) Some clipboards have one center screw under
the sticker on the front of the wheel.
If so, remove screw.
b) Some clipboards have two screws on the
backside of wheel. If so, remove.
2. Now you should be able to see a nut in the middle of
wheel. Remove the nut. (Figure 2)
3. Remove steering wheel ~ some models have puller
holes, some do not.
NOTE: Straighten wheel for alignment before
removing wheel.
a) If your wheel has puller holes, use a wheel
puller to remove the wheel.
b) If there are no puller holes, use a 2-finger puller
and pull on shoulder behind wheel. (Tip: use
2-finger puller gently. If plastic on wheel begins
to deform, stop and tap on the top of puller.
Sometimes the shock of impact will loosen the
wheel.)
(Figure 3)
4. Assemble your new wheel onto your adaptor with
the screws provided with the adaptor. Do not install
center cap.
NOTE: Orientation of wheel on adaptor
is not important at this time. (Figure 4)
5. To install steering wheel on cart, make sure the front
wheels on cart are straight. Slip adaptor onto the top
of column. The adaptor should slip over spline
and seat down so that the threads are sticking up
approximately ½” through the adaptor.
(Figure 5)
6. Install nut, finger tight. Carefully drive cart back &
forth to make sure the wheel is straight. If not, remove
wheel and index wheel 1 tooth on spline. Tighten the
nut to approximately 45ft lbs.
(Figure 6)
7. Lastly, install the center cap (not included with some
models). Moisten the o-ring and push in with the
palm of your hand. NOTE: Some wheels include a
horn button. They will fit, but will not make the horn
work.
(Figure 7)
8. Your installation is now complete! (Figure 8)