ididit Retrofit Steering Column: Jeep Column to a Painless Wiring Kit - Manual

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
ididit Jeep Column to a Painless Wiring Kit Instructions
(The following instructions are not needed if using an original harness. If using your original wiring see column instruction booklet)
For Part Number’s 1520800010, 1520800020, 1520800051
Instruction #: 8000020035 REV 06/14
FOR PAINLESS KIT #: 10110
IDIDIT COLUMN COLOR PAINLESS WIRING COLOR FUNCTION
Power: Red 734 #1
(old kit)
934 #1
(new kit)
Red Battery Power
See Note 1: 734 #2 (old kit) 934 #2 (new kit) Red Battery Power
Starter/Crank Purple 719 (old kit) 919 (new kit) Light Blue Starter Engage
Accessory Feed: Brown 790 (old kit) 932 (new kit) Brown Accessory Feed
Ignition Feed: Pink 731 (old kit) 931 (new kit) Red/White Ignition Supply to Coil +
See Note 2: 733 (old kit) 933 (new kit) Yellow Feed to Fuse Panel
Not used, see Note 3: 760 (old kit) 968 (new kit) Black Ignition Ground
Note 1: ididit’s Red wire needs to be connected with both Reds 734 #1 (934 #1 new kit) and 734 #2 (934 #2
new kit) from the Painless wiring kit.
Note 2: ididit’s Pink wire needs to be connected to both 731 (931 new kit) and 733 (933 new kit). 733 (933
new kit) is an accessory feed that stays hot during crank (fuel pump) and others.
Note 3: ididit does not use the Black wire. This wire is for an idiot light bulb check. If you want this feature use
a two prong toggle switch and ground one side. Then connect Painless # 760 (968 new kit) to the
other side. This will activate the lights allowing you to check to make sure the bulbs are good.
FOR PAINLESS KIT #: 10106
IDIDIT COLUMN COLOR PAINLESS WIRING COLOR FUNCTION
Power: Red 734 #1 Red Battery Power
See Note 1: 734 #2 Red Battery Power
Starter/Crank Purple 719 Purple Starter Engage
Accessory Feed: Brown 732 Brown Accessory Feed
Ignition Feed: Pink 731 Pink Ignition Supply to Coil +
See Note 2: 733 Orange Feed to Fuse Panel
Note 1: ididit’s Red wire needs to be connected with both Reds 734 #1 and 734 #2 from the Painless wiring
kit.
Note 2: ididit’s Pink wire needs to be connected to both 731 and 733. 733 is an accessory feed that stays hot
during crank (fuel pump) and others.