ididit Steering Wheel Adaptor: 1953-66 Corvette Adaptor - Manual

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
1953-62 Corvette Adaptor Instructions
For Part Number’s 2202360020, 2202360030, 2202360040, 2202360051
Instruction #: 8000010016 REV 03/14
Prior to installing this wheel adaptor verify that your
road wheels are pointing straight ahead.
Adaptor Preparation:
1. Remove the (6) 10-32 x 3/4” wheel adaptor flat head
screws (Figure 1A)
2. Remove (3) 8-32 x 1/2” socket cap screws (Figure 1B)
Disconnect Battery
Installation:
1. Remove the nut from the top shaft of your steering
column.
2. Rotate the Horn Cam on the steering column so that the
male tube is aligned to the 10:30 position. (Figure 2)
3. Next, install the wheel adaptor. Align the 1/2” hole
on the adaptor to the male end of the Horn Cam. Now
push the adaptor onto the splined end of the steering
column. If the splines of the column and the adaptor
do not line up, simply wiggle or move the shaft just
enough so that the adaptor slides onto the splines.
4. Install the adaptor nut back onto the top shaft of the
column and torque to 35 ft. lbs. (Figure 3)
5. Next, line up the steering wheel as shown in Figure
7 and install the (6) 10-32 x 3/4” flat head screws to
secure the steering wheel to the adaptor.
6. Install the horn wire by it pushing down into the horn
tube and gently turning it an 1/8 turn to the right Note:
The Horn Cam has a cutout and the black sleeve on
the horn wire has a nub on it. Line up the nub with
cutout and push down to compress the spring. Once
compressed, turn the black sleeve of the Horn Cam
1/8 of an inch clockwise.
(Figure 4)
7. Line up the three “ears” of the new Horn Contact and
using a 9/64” Allen wrench install the (3) 8-32 x 1/2”
socket cap screws until they are tight.
(Figure 5)
8. Lastly, install the horn button with the dimples
matching the dimples from the new horn contact
plate. Press firmly until the horn button is secure.
(Figure 6)
Your installation is now complete!