Flex-a-Lite 65: Puller mode, does not include controls Chevy S-10 & S-10 Blazer Electric Fan - Manual

Chevy S-10 & S-10 Blazer Electric Fan
Part #60: Puller mode, includes thermostatic control.
Part #65: Puller mode, does not include controls.
(1982 to 2002)
Installation Instructions
1. Disconnect the battery ground cable.
2. Remove the top (3) shroud screws. Reference
Diagram B
3. Remove the (2) screws on each side of the
upper shroud.
4. Remove the top of the shroud.
5. Remove the (4) nuts securing the clutch/fan
assembly to the water pump shaft and
remove assembly.
6. Reinstall nuts on water pump shaft to secure
water pump pulley.
7. Install spacer and mounting bracket on the
bottom of the electric fan shroud securing
with the nuts and bolts provided. Note:
Shroud holes for mounting brackets are
offset more from edge of shroud on the top
side.
Reference Diagram A for bracket installation
Reference Diagram B for proper fan orientation
Mount Control Module on the
Passenger Side of the Vehicle
8. Lift radiator approximately 2 inches and
hook the bottom mounting bracket under the
lower radiator C-channel so that the fan is
mounted on the center of the radiator Note:
Installation is facilitated by angling the top
of the fan away from the radiator while
hooking the bottom bracket.
9. While holding the top of the electric fan
against the radiator install the top mounting
spacer and bracket using the nuts and bolts
provided.
10. Follow wiring instructions in the next
section.
11. Reinstall upper radiator shroud and fasten
using the original bolts.
12. Reconnect battery ground cable.
Diagram A
Diagram B
Mounting
Bracket
Spacer
Control Module
Upper Shroud
Side Screws
Top Shroud
Screws
rev. 06-22-05 99925 page 1 of 2