Extang Encore Torno General Installation - Manual (Page 4)

11
Check to see that both tail panel latches make proper contact with the EnCore side rails.
If tail panel latch
doesnʼt contact side
rail properly…
…hand-loosen latch screws
and slide the latch toward
the side rail.
Retighten
screws by hand.
If the tail panel latch is
not tight to the EnCore
side rail, add spacer to
side rail lip.
Extang Corporation, 5400 S. State Road, Ann Arbor, MI 48108, 734 677-0444, Fax: 734 677-8409 Visit us at: extang.com
Rotate lock cylinder (unlocked) 1/4 turn (90
degrees) clockwise two to three times to ensure
lock snaps back to original position.
12
Ensure front panel latch system is functioning properly.
Verify front panel is
securely latched on
both sides of truck.
SECURE THE FOLDED ENCORE COVER TO
FRONT OF CAB WITH BOTH CAB BUCKLES.
DOUBLE CHECK TO BE SURE BUCKLES ARE
SECURELY FASTENED. ALSO SECURE
TETHERS LOCATED ON THE CENTER PANEL
TO EACH SIDE RAIL. VEHICLE MAY BE
DRIVEN WITH THE COVER IN THIS SECURE,
FOLDED POSITION.
Check For Tail Panel Latch Engagement
Do Not Drive the
vehicle with the
tonneau cover on
the truck until the
lock snaps back to
original position and
the front panel is
securely latched on
both sides of truck!