Extang Encore Torno General Installation - Manual (Page 3)

With tailgate open, unfold tail
panel and press down onto
truck bed.
Tonneau should now
be secure.
6
Extang Corporation, 5400 S. State Road, Ann Arbor, MI 48108, 734 677-0444, Fax: 734 677-8409
9
NOTE: To insure a
better seal, always
close panel before closing
tailgate.
Before this step,
be sure you
UNLOCK the
panel latch.
Unfold front panel and position
cab and middle panels over
truck bed making sure retaining
hooks engage pins in drain rail.
Press down on cab panel to lock
in place
10
Visit us at: extang.com
7
Lay EnCore cover back
over center of truck bed.
8
Secure EnCore tethers, located under
center panel, to each side rail. Tether
hooks must be attached to side rails
any time cover is on the vehicle.
Drill a 3/4” hole through a truck
bed knockout plug, truck bed or
bedliner. Insert the drain hose
through that hole.
Stand the bundled panel system on
the drain rails so that the retaining
hooks line up with the two pins inside
the drain channel as shown here.
Be careful not to
scratch the truck
finish at this step!