Extang Platinum BlackMax: GMC/Chevy Stepside 88-98 - Manual

PARTS INCLUDED IN YOUR KIT. You may want to lay them out in this manner for accessibility.
MISSING PARTS???
call Extang at
1-800-877-2588
Any and all needed parts will be shipped to you
directly. (DO NOT return whole kit to store).
Extang Corporation
5400 S. State Road
Ann Arbor, MI 48108
734 677-0444, Fax: 734 677-8409
Register your warranty at:
extang.com
I t e m N o . 0 0 1 3 - 1 4 0 3 R H P r i n t e d i n U . S . A .
INSTALLATION SHEET -
GMC/Chevy Stepside ʻ88–ʼ98
3
Remove paper tape from all rails. Discard properly.
Foam has NO adhesive to
touch truck finish.
Wash truck bed.
P L E A S E
D O N O T
L I T T E R
Pull back on the ClickLock TM
release and remove one
corner from cab rail.
Feed tarp dowel into cab rail.
(NOTE: For easiest feeding action, place tarp on a flat
smooth surface, and keep dowel straight while feeding
into cab rail. Caution, pavement may scuff tarp.)
Reinsert corner piece into
cab rail until it “clicks” and
locks into place.
ClickLock TM
1 2
NOTE:
B LACK M AX has snaps on all rails.
4
NEW Improved
“DOUBLE HOOK”
Side Rail Clamps
Tarp
Bows
Side Rails
Torx Wrench
Clamp
Bolts
TuffKlamps™
Tailgat
e R
ail
Allen Wrench
For Classic Platinum only (This step does not apply to BlackMax)
Cab R
ail
(BlackMax includes snaps on this rail)
Corner
Pieces
Hex
Bolts
Wall Plates
Place assembly
over truck box.
Center between cab
and tailgate.
Off the truck bed,
connect the end rails
to the two side rails.