Boonton 4240 RF Power Meter - Manual (Page 89)

Boonton 4240 Series RF Power Meter
STATus:OPERation:NTRansition
alue of the negative transition filter bitmask for the Operation status group.
the negative transition filter causes a 1 to 0 (negative) transition in the
Syntax:
5)
:OPERation:PTRansition
value of the positive transition filter bitmask for the Operation status group.
the positive transition filter causes a 0 to 1 (positive) transition in the
Syntax:
lue>
t:
transition filters to the default state. The Operational Enable and
isters are both cleared so an SRQ will not be generated for these
Syntax:
Description: Set or return the v
Setting a bit in
corresponding bit of the Operation Condition register to cause a 1 to be written in the associated
bit of the Operation Event register.
STATus:OPERation:NTRansition
Argument: = 0 to 65535
Returns: 16-bit register value (0 to 6553
STATus
Description: Set or return the
Setting a bit in
corresponding bit of the Operation Condition register to cause a 1 to be written in the associated
bit of the Operation Event register.
STATus:OPERation:PTRansition
Argumen = 0 to 65535
5) Returns: 16-bit register value (0 to 6553
STATus:PRESet
Description: Sets SCPI enable registers and
Questionable Enable mask reg
conditions. All bits for the device and questionable calibration registers are enabled. All positive
transition filters are enabled and all negative transition filters are cleared.
STATus:PRESet
Argument: None
Remote Operation
5-29