Boonton 4240 RF Power Meter - Manual (Page 77)

Boonton 4240 Series RF Power Meter
5.5.5 FETCh Queries
The FETCh? group of queries is used to return specific measurement data from a measurement cycle that has been INITiated
and is complete or free-running. FETCh? performs the data output portion of the measurement. FETCh? does not start a
new measurement, so a series of FETCh? queries may be used to return more than one set of processed measurements from a
complete set of acquired data. FETCh? usually returns the current value of measurements, and should be used anytime free
running data acquisition is taking place (INITiate:CONTinuous ON). If FETCh? is used for single measurements
(INITiate:CONTinuous OFF), no data will be returned until a measurement has been INITiated and is complete.
FETCh:CW:POWer?
Syntax:
asurement condition code.
ETCh:KEY?
Return the key code of the last key depressed; e.g. MENU = 1.
Returns:
de
FREQ 4
AVG 8
Zero/Cal 16
REF Level 32
Up Arrow 64
Left Arrow 128
Enter 256
Right Arrow 512
Down Arrow 1024
Description:
Return current average amplitude reading in channel units.
FETCh[1|2]:CW:POWer?
Returns: CC, average power
Where CC is the me
F
Description:
Syntax: FETCh:KEY?
key code
Key Co
Menu 1
Sensor 2
Remote Operation
5-17