Boonton 4240 RF Power Meter - Manual (Page 100)

Boonton 4240 Series RF Power Meter
5-1. SCPI COMMAND SUMMARY (continued)
SENSe[1|2]:CORRection:CA
= -3.00 to 3.00
et/return duty cycle correction factor in percent.
umeric value> = 0.0 to 100.0%
channel frequency.
eric value> = 0.01e9 to 110.00e9 Hz
SENSe[1|2]:CORRection:OFFSet Set/return sensor offset value in dB.
= -99.99 to 99.99
]:FILTer:STATe Set/return filter state.
= OFF, AUTO, ON
Set or return the current length of the integration filter on the
selected channel. = 0.05 to 20.00 seconds
Return value of Device Condition Register
Set/return value of Device Enable Mask
Return value of Device Event Register
Set/return the Negative Transition filter
n the Positive Transition filter
Set/return value of Operation Enable Mask
Tus: PERation:EVE ? ent Register
Tus PERation:NTRansition Set/return the ativ Transit
us PERation:PTRa sition n filter
t SCPI registers to default states
tionable Condition Register
STATus:QUEStionable:ENABle
Set/return value of Questionable Enable Mask
ve transition filter
able calibration condition register
TATus:QUEStionable:CALibration:ENABle Set/return value of the questionable calibration enable mask
LFactor Set correction factor in dB.
SENSe[1|2]:CORRection:DCYCle S
SENSe[1|2]:CORRection:FREQuency
Set
SENSe[1|2
SENSe[1|2]:FILTer:TIMe
STATus:DEVice:CONDition?
STATus:DEVice:ENABle
STATus:DEVice:EVENt?
STATus:DEVice:NTRansition
STATus:DEVice:PTRansition
Set/retur
STATus:OPERation:CONDition?
Return value of Operation Condition Register
STATus:OPERation:ENABle
STA
O Nt Return value of Operation Ev
STA
:O Neg e ion filter
STAT :O
n Set/return the Positive Transitio
STATus:PRESet
Set device dependen
STATus:QUEStionable:CONDition?
Return value of Ques
STATus:QUEStionable:EVENt?
Return value of Questionable Event Register
STATus:QUEStionable:NTRansition
Set/return the negative transition filter
STATus:QUEStionable:PTRansition
Set/return the positi
STATus:QUEStionable:CALibration:CONDition? Return value of the question
S
Remote Operation
5-40