Rear cradle bushings bk002 (continued) – BMR Suspension BK002 User Manual
Page 4
Rear Cradle Bushings
BK002 (Continued)
15.
Lift the cradle back up against the body taking care to properly align the rear dowels.
16.
Insert the factory cup washers and bolts and tighten all four mounting bolts to 130 ft/lbs. Image 13.
17.
Plug the fuel pump wiring harness back in.
18.
Re-install the exhaust.
19.
Reconnect the O2 sensors.
20.
Bolt the driveshaft tunnel brace back into place and torque to 45 ft/lbs.
21.
Install the rear wheels and lower the vehicle.
WWW.BMRSUSPENSION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this
vehicle. As such, buyer assumes all risk of any damage caused to the vehicle/person during installation or
use of this product.
- AA016 (2 pages)
- AA017 (1 page)
- AA018 (3 pages)
- AA028 (1 page)
- AA005 (3 pages)
- BCA005 (1 page)
- BK043 (2 pages)
- CCK002 (3 pages)
- RB001 (2 pages)
- RSK001 (1 page)
- RSK007 (2 pages)
- SB035 (3 pages)
- BCA003 (1 page)
- XSB006 (1 page)
- DSL002 (2 pages)
- TCA007 (1 page)
- AWK-1 (1 page)
- PSB001 (1 page)
- TCA018 (1 page)
- BCK003 (4 pages)
- BK046 (4 pages)
- BK006 (1 page)
- BK008 (1 page)
- BK016 (3 pages)
- BK017 (4 pages)
- BK018 (2 pages)
- BK019 (1 page)
- BK024 (4 pages)
- BK026 (4 pages)
- BK027 (5 pages)
- BK029 (4 pages)
- BK039 (4 pages)
- BK040 (3 pages)
- CCK004 (2 pages)
- DSL014 (2 pages)
- DSL015 (1 page)
- DTB004 (1 page)
- ELK004 (1 page)
- ELK005 (1 page)
- ELK006 (1 page)
- ELK009 (1 page)
- ELK011 (1 page)
- MM004 (2 pages)
- MTCA030 (2 pages)
- S5003 (4 pages)