BMR Suspension SP029 - Manual

SP027 LOWERING SPRINGS
TOOLS REQUIRED:
• 15mm wrench
• Sockets – 15mm, 18mm, 21mm
• Hydraulic floor jack
• 4 Jack stands
• Pry-bar
INSTALLATION:
1.
Lift vehicle and support with jack stands under the rocker pinch welds.
2. Using a 15mm socket, remove the quad shock bolts as shown in IMAGE 1.
3. Start with the rear. Using a 15mm wrench and an 18mm socket, remove the lower shock bolts as shown
in IMAGE 2 then allow the rear end to lower until the springs are loose.
4. Remove the springs. (IMAGE 3)
5. Remove the rubber upper spring sleeve from the OE springs and place it over the BMR spring as shown
in IMAGE 4.
6. Install the BMR springs making sure the springs are properly on their seats. Make sure to use the lower
spring isolater on the control arms.
7.
Lift the rear and re-connect the shocks. Tighten the bolts.
8. Re-connect the quad shocks and tighten the bolts.
9. Proceed to the front of the vehicle and remove the front wheels/tires.
CONTINUED