BMR Suspension SP012 - Manual (Page 3)

LOWERING SPRINGS FOR 2005-PRESENT FORD MUSTANG (Cont.)
Part #’s SP009, SP011, SP012
10. Disassemble the individual assembly components
and the OE spring. Place the BMR spring onto the
strut and index it in the lower spring seat as shown
in IMAGE 5.
11. Assemble the strut/spring
assembly in the order shown in
IMAGE 6 then tighten the upper
strut nut to 76 ft/lbs.
12. Re-install the strut/spring
assembly into the strut tower and
thread the (4) retaining bolts onto
the strut mount. Torque to 26
ft/lbs. using a 13mm socket.
13. Bolt the strut assembly to the
spindle and snug the bolts. Line
up the strut and bolts
to the marks made in step 6 then
tighten the bolts to 166
ft/lbs. NOTE: the alignment
marks made previously will only
get the alignment close. Your
newly lowered vehicle will still need an alignment to reach the desired specifications.
14. Re-install the brake line retainer and tighten the 10mm bolts to 15 ft/lbs.
15. Re-install the ABS wire to the strut tab.
16. Re-install the sway bar end link to the strut and tighten the nut to 85 ft/lbs.
17. Duplicate these steps for the other side then re-install the wheels and tires.