BMR Suspension SP012 User Manual
Page 2
LOWERING SPRINGS FOR 2005-PRESENT FORD MUSTANG (Cont.)
Part #’s SP009, SP011, SP012
3. Locate the ABS line where it attaches to the
strut. Slide the line out of the bracket as
illustrated in IMAGE 2.
4. Using a 10mm socket, remove the brake line
retainer bolt where it attaches to the strut. See IMAGE 2 for reference.
5. Using an 18mm socket, remove the upper sway bar end link from the strut as illustrated
in IMAGE 1 on the previous page.
6. Using a permanent market, grease pencil, or paint pen, mark the strut and bolts along
their mating surface. This mark will be used later during reassembly. See IMAGE 3 for
reference.
7. Support the rotor/hub/caliper assembly then
remove the (2) large bolts that retain the strut to
the spindle using an 18mm wrench and socket.
See IMAGE 3 for reference.
8. Remove the strut/spring assembly.
9. The next step is removing the spring from the
strut. Using a spring compressor, compress the
spring to relieve tension from the upper mount.
See IMAGE 4 for reference. With the spring
compressed, remove the upper strut nut using a
19mm socket.