BMR Suspension CAB005 - Manual (Page 3)

3
CONTROL ARM RELOCATION BRACKETS (Cont.)
12. Slide the BMR Drivers’ side relocation bracket up onto the mount. The rear leg of the
mount should fit up into the OE bracket of the rearend on the backside of the Panhard rod
mount. Insert the provided spacer behind the upper hole as shown in IMAGE 11.
13. Once properly positioned, re-install the damper weight and leave the bolt loose. See
IMAGE 12. NOTE: if your vehicle did not come with damper weights installed, use the
provided 12mm x 30mm bolts for this mounting position.
14. As in step #5, install the gold spacer and 14mm x 100mm bolt and nut into the OE
control arm mounting hole and leave the bolt loose. See IMAGE 13.
15. Re-install the Panhard rod mounting bolt and tighten to 129 ft/lbs. using an 18mm
wrench or socket. See IMAGE 14.
16. Tighten the main 14mm bolt and nut to 129
ft/lbs. using a 22mm wrench and socket.
17. Tighten the damper weight bolt to 45 ft/lbs
using a 15mm wrench.
18. Install the control arm into the desired
mounting hole and insert the provided
14mm x 100mm bolt and nut as shown in
IMAGE 15. Tighten to 129 ft/lbs.
19. Lower vehicle.
WWW.BMRSUSPENSION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As
such, buyer assumes all risk of any damage caused to vehicle/person during installation or use of this product.