BMR Suspension CAB005 - Manual

1
CONTROL ARM RELOCATION BRACKETS
2005-Present Ford Mustang
Tools required:
Wrenches: 15mm, 18mm, 22mm
Sockets: 18mm, 22mm
Jack and Jack Stands
Pry-bar, Hammer
Installation:
1. Lift rear of vehicle and place stands under the rear axle.
2. Begin with the passenger side. Using a 15mm wrench, loosen the axle damper weight
mounting bolt and remove the damper as shown in IMAGE 1. NOTE: please disregard
this step if your vehicle did not come with these weights.
3. Using an 18mm socket or wrench, remove the lower control arm bolt as shown in
IMAGE 2. Lower control arm to gain access to mount area.
4. Slide the passenger side BMR Relocation Bracket over the OE mount and align the holes.
Re-install the axle damper weight but do not
tighten the bolt yet. (IMAGE 3) NOTE: if
your vehicle did not come with damper
weights installed, use the provided 12mm x
30mm bolts for this mounting position.
5. Locate the gold colored bolt spacer and a
14mm x 100mm bolt from the provided
hardware pack and install it into the OE
mounting hole as shown in IMAGE 4. Do
not tighten yet. When installed, it should
look like IMAGE 5.