BMR Suspension CAB005 - Manual (Page 2)

2
CONTROL ARM RELOCATION BRACKETS (Cont.)
6. Locate the short 14mm bolt, washer and nut in the hardware packet and insert it into the
upper mount of the relocation bracket as shown in IMAGE 6. Slide a 22mm wrench up
into the control arm mount and onto the nut. Tighten the bolt to 129 ft/lbs. using a 22mm
socket.
7. Tighten the sleeve and cross-bolt to 129 ft/lbs. then tighten the upper damper bolt to 45
ft/lbs. using a 22mm socket and wrench.
8. Position the control arm into the desired hole as shown in IMAGE 7 and insert a new
14mm x 100mm bolt and nut. Tighten the bolt to 129 ft/lbs.
9. Move to the drivers’ side next and remove the axle damper weight using a 15mm wrench
as shown in IMAGE 8. NOTE: please disregard this step if your vehicle did not come
with these weights.
10. Using the 18mm wrench, loosen the control arm mounting bolt and lower the control arm
out of the way. See IMAGE 9.
11. Using an 18mm wrench, remove the
Panhard rod bolt as shown in IMAGE 10.