BMR Suspension BK024 - Manual (Page 4)

Rear Subframe Bushings
BK024 (Continued)
17. Raise the entire assembly back into position taking care to properly align the rear dowels. Insert the
bolts and factory retainer plates then tighten to 130 ft/lbs.
18. Re-connect the driveshaft and tighten the (3) mounting bolts to 85 ft/lbs.
19. Bolt the calipers back to the spindles and tighten the bolts to 65 ft/lbs.
20. Re-connect the rubber brake lines to the upper control arms.
21. Attach the emergency brake cables back to the spindles.
22. Re-connect the ABS plug.
23. Plug the fuel pump wiring harness back in.
24. Re-install the exhaust.
25. Bolt the driveshaft tunnel brace back into place and torque to 45 ft/lbs.
26. Install the rear wheels and lower the vehicle.
WWW.BMRSUSPENSION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such,
buyer assumes all risk of any damage caused to the vehicle/person during installation or use of this product.