AirSep MN137-1 D - Manual (Page 72)

VisionAire™ EN
AirSep ® Corporation EN-3
MN137-1 rev. D
Clean the cabinet, control panel, and power cord only with a
mild household cleaner applied with a damp cloth or sponge,
and then wipe all surfaces dry. Do not allow any liquid to
get inside the device.
No modification of this equipment is allowed.
The unit should not be used adjacent to or stacked with other
equipment. If adjacent or stacked use is unavoidable, the
device should be observed to verify normal operation.
Federal (USA) law restricts this device to sale or rental by
order of a physician or other licensed health care provider.
AirSep recommends an alternate source of supplemental
oxygen in the event of a power outage, alarm condition, or
mechanical failure. Consult your physician or Equipment
Provider for the type of reserve system required.
It is very important to follow the prescribed level of oxygen
flow. Do not increase or decrease the flow until you first
consult your physician.
Ensure concentrator is operated in an upright position.
EN VisionAire™
EN-4 AirSep ® Corporation
MN137-1 rev. D
Position the unit away from curtains or drapes, hot air
registers or heaters. Be certain to place the unit on a flat
surface and make sure all sides are at least 1 foot (30 cm)
away from a wall or other obstruction. Do not place the unit in
a confined area. Choose a dust and smoke free-location away
from direct sunlight. Do not operate the unit outdoors.
Do not operate this unit in a restricted or confined space
where ventilation can be limited. This can cause the device to
overheat and affect performance.
In the event of an alarm or you observe the unit is not working
properly; consult the troubleshooting section of this manual. If
you cannot resolve the problem, consult your Equipment
Provider.
The Oxygen Concentrator may be used during sleep under
the recommendation of a qualified clinician.
If the humidifier bottle tubing is not properly connected to the
humidifier bottle fitting or to the oxygen outlet, an oxygen leak
can occur.
Storing the device outside of its temperature specifications
may affect performance (refer to the specification section of
the manual).
Do not position the unit so that it is difficult to access the
power cord.