Alpine IVA-C801 - Manual (Page 61)

59
-EN
Installation
Installing the Monitor
• Place of installation
Before determining the position of installation,
check that the display will not hamper gear
shifting when it is opened and closed in that
position.
NOTE
Install at an angle of within 30 degrees from the
horizontal.
1
Slide mounting sleeve from main unit (see
Removal Procedure below). Slide the mounting
sleeve into the dashboard. Install the supplied
bracket to the monitor.
2
IVA-C801/
CVA-1006
Front
Frame
(Included)
Bolt Stud
Metal
Mounting
Strap
Screw
Hex Nut
(M5)
Ground
Lead
Lock Pin
Chassis
Screws (M5x6)
(Included)
Mounting
Bracket
(Included)
Dashboard
Mounting Sleeve
(Included)
IVA-C801/
CVA-1006
Washers
(Included)
Reinforce the monitor unit with the metal
mounting strap (not supplied). Secure the ground
lead of the unit to a clean metal spot using a
screw (
≤ ) already attached to the vehicle's
chassis.
NOTE
For the screw marked ≤≤, use an appropriate screw
for the chosen mounting location.
Connect each input lead coming from an amplifier
or equalizer to the corresponding output lead
coming from the left rear of the IVA-C801/CVA-
1006. Connect all other leads of the IVA-C801/
CVA-1006 according to details described in the
Connections section.
3
Slide the IVA-C801/CVA-1006 into the
dashboard. When the unit is in place, make sure
the locking pins are fully seated in the down
position. This can be done by pressing firmly in
on the unit while pushing the locking pin down
with a small screwdriver. This ensures that the
unit is properly locked and will not accidentally
come out from the dashboard. Install the
supplied Front Frame.
Removal
1. Use a small screwdriver (or similar tool) to push
the locking pins to the "up" position (see Step 3).
As each pin is unlocked, gently pull out on the
unit to make sure it does not re-lock before
unlocking the second pin.
2. Pull the unit out, keeping it unlocked as you do
so.