Setting automatic opening/ closing of monitor, Adjusting brightness of picture – Alpine IVA-C801 User Manual
Page 49
47
-EN
Setting Automatic Opening/
Closing of Monitor
When the Automatic Opening/Closing mode is
"ON," the monitor automatically opens when the
ignition key is turned to the "ACC" or "ON"
position. The monitor automatically closes when
the ignition key is turned OFF.
NOTE
After carrying out the steps 1 to 3 of "To display the Setup
mode screen" described on page 40, perform the
operation show below.
1
Press the
SOURCE
button.
The main menu appears on the display.
2
Press the
6
(SETUP) button.
The Setup mode screen appears.
3
Rotate the rotary encoder and select "AUTO
OPEN."
The display shows the Function Guide.
4
Press the
2
(ON) button to set the Auto
Opening mode ON.
To set the Auto Opening mode OFF, press the
1
(OFF) button. If set to the "OFF" position, the
monitor should be manually opened or closed by
pressing the
OPEN/CLOSE
button.
5
Press the
FUNC
(RETURN) button, the display
returns to the main menu screen.
NOTE
Immediately after inputting titles or changing the settings
of Setup Mode or Display Mode (While the system is
inputting the titles or data automatically) do not turn the
ignition key (engine key) to OFF.
Otherwise, the title may not be written, or the settings
may not be changed.
Adjusting Brightness of Picture
To switch to the display mode screen or to the
picture mode:
To watch a video source, your vehicle must be
parked with the ignition key in the ACC or ON
position. To do this, follow the procedure below.
1.
Push the foot brake to bring your vehicle to a
complete stop at a safe location. Engage the
parking brake.
2.
Keep pushing the foot brake and release the
parking brake once then engage it again.
3.
While the parking brake is being engaged the
second time, release the foot brake.
NOTE
For automatic transmission vehicles, place the transmission
lever in the Park position.
Now, the locking system for the Display mode
operation has been released. Unless the ignition key
is turned to the OFF position, the Display mode can
be activated by engaging the parking brake without
performing the above procedure (1 through 3).
Each time the ignition key is turned to the OFF
position, perform the above procedure.
1
Press the
SOURCE
button.
The main menu appears on the display.
2
Press the
5
(DISPLAY) button.
The Display mode screen appears.
3
Rotate the rotary encoder and select "BRIGHT"
to activate the Brightness Adjustment mode.
The display shows the Function Guide.
4
Press the
1
(
;
DARK) to make the picture darker
or press the
3
(LIGHT
:
) to make the picture
brighter. You can adjust the brightness between
MIN (–15) and MAX (+15). When it reaches the
minimum or maximum point, the display shows
"MIN" or "MAX" respectively. To quickly set to the
center position, press the
2
(±0) button.
5
When the adjustment has been completed, press
the
FUNC
(RETURN) button. The display returns
to the main menu screen.
NOTES
• With the Display mode screen displayed, pressing and
rotating the rotary encoder can adjust the volume level.
• Immediately after inputting titles or changing the
settings of Setup Mode or Display Mode (While the
system is inputting the titles or data automatically) do
not turn the ignition key (engine key) to OFF.
Otherwise, the title may not be written, or the settings
may not be changed.