Alpine IVA-C801 - Manual (Page 57)

55
-EN
CD (IVA-C801 only)
CD playback sound is wavering.
• Moisture condensation in the CD Module.
- Allow enough time for the condensation to evaporate
(about 1 hour).
CD insertion not possible.
• A CD is already in the CD player.
- Eject the CD and remove it.
• The CD is being improperly inserted.
- Make sure the CD is being inserted following
instructions in the CD Player Operation section.
Unable to fast forward or backward the CD.
• The CD has been damaged.
- Eject the CD and discard it; using a damaged CD in
your unit can cause damage to the mechanism.
CD playback sound skips due to vibration.
• Improper mounting of the unit.
- Securely remount the unit.
• Disc is very dirty.
- Clean the disc.
• Disc has scratches.
- Change the disc.
CD playback sound skips without vibration.
• Dirty or scratched disc.
- Clean the disc; damaged disc should be replaced.
Indication for CD Player (IVA-C801 only)
• Protective circuit is activated due to high temperature.
- The indicator will disappear when the temperature
returns to within operation range.
• No CD is inserted.
- Insert a CD.
• Although a disc is inserted, "NO DISC" is displayed
and the unit does not start to play or eject the disc.
- Remove the disc by following these steps:
1) Press the c button.
The movable display will open.
2) Press the c button again for at least 3 seconds while
the movable display is open.
• Mechanism error.
1) Press the c button and eject the CD.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting,
press the c button again.
If the error indication still does not turn off after
pressing the c button for a few times, consult your
Alpine dealer.
NOTE
When the "ERROR" is displayed:
In case that the disc cannot be ejected by pressing the c
button, press the RESET switch (refer to page 8) and
press the c button again.
If not ejecting, consult your Alpine dealer.
HI-TEMP
ERROR
NO DISC