Converting a vsc volume to a normal volume 108, Converting a vsc volume to a normal volume – HP LUN Configuration Manager XP Software User Manual
Page 108
108
HP StorageWorks LUN Configuration Manager XP: user’s guide
Converting a VSC volume to a normal volume
Caution
The CV to Normal Volume function is a destructive operation. The data on
the CV being converted is erased. Back up the data before performing this
operation.
The CV to Normal Volume function allows you to convert a VSC volume
back to a normal volume. This operation deinstalls all CVs under a VSC
volume and then reformats the VSC volume as a normal volume. If the
VSC volume was originally formatted as a VSC volume by the HP
representative (using the service processor–SVP), you cannot convert it
back to normal using the remote console. If the volume was converted to a
VSC volume using the remote console, you can convert it back to normal
using the remote console.
The requested VSC-to-normal conversion operation does not occur until
you select OK on the VSC Confirmation window at the end of the
procedure.
To Convert a VSC volume to a normal volume:
1. Open the Function Select window. See “Starting VSC operations”
2. Choose CV to Normal Volume on the Function Select window.
3. Select OK.