HP EX475 MediaSmart Server - Manual (Page 125)

Troubleshooting 7-11
d While the Health indicator is blinking blue and red , use a
paper clip to press the recessed Status/Recovery button until it
clicks.
Recovery mode is initiated.
e If recovery mode is successfully initiated, the Health indicator light
blinks purple and red repeating.
6 On the Rebooting your server into recovery mode dialog box,
click Next, and then follow the instructions on each dialog box.
During the recovery process, the following may happen:
ƒ
If the recovery program cannot find the server, see No server found on
page 7-12 .
ƒ
If the Server Recovery cannot recover the partition data, the progress
bar will go to 100% and then back to zero and start over.
ƒ
If the recovery fails, see Recovery fails on page 7-12 .
ƒ
If the HP MediaSmart Server or Windows Home Server Connector
software was not uninstalled in step 4 above, you may get a message
that the software already exists and would you like to reinstall. If you
get this messsage, select Yes.
7 After the Server Recovery or Factory Reset completes, the server
automatically restarts. Before taking the next step wait until the Health
indicator light is solid blue
.
8 You must reinstall the software on each of your computers, including the
computer that you used to perform the recovery—otherwise, you won’t be
able to use the server.