HP Optical Jukeboxes - Manual (Page 57)

Chapter 3 3-17
Operating the Jukebox
Setting the SCSI IDs
Op
er
atin
g
th
e
Juke
b
o
x
Changing the Current SCSI IDs
READY > ADMIN * > SCSI ID’S * > SET ID’S *
NOTE If you are unfamiliar with basic SCSI addressing or LUN addressing, refer to
Appendix B.
Start with READY in the display.
1. Press NEXT until ADMIN * displays, and then press ENTER .
2. Enter the administration password.
Instructions for entering this password are in “Entering the Administration
Menu Password” previously in this chapter.
3. Press NEXT until SCSI ID’S displays, and then press ENTER .
4. VIEW ID’S displays. Press NEXT until SET ID’S displays and then press
ENTER .
BUS 1 * displays. If you want to change the IDs on Bus 1, press ENTER .
If you want to change the IDs on Bus 2, press NEXT until BUS 2 * displays and
then press ENTER .
If you are using basic SCSI addressing (LUN mode OFF):
JKBX ID # LUN # or DRV # ID # LUN # displays. (JKBX ID #
stands for the current ID of the jukebox controller, LUN # is the current logical
unit number, and DRV # ID # is the current ID setting for the displayed drive
number.) When using basic SCSI addressing, the LUN # is always 0.
If you are using LUN addressing (LUN mode ON):
JKBX BUS 1 # or DRVs BUS 1 # displays on Bus 1, or DRVs BUS 2 #
displays on Bus 2. (“#” is the current ID for the jukebox controller and drives
when LUN mode is ON.)
5. Press NEXT until the setting you wish to change displays, and then press ENTER .
The # (current ID) begins flashing.