HP Optical Jukeboxes - Manual (Page 17)

Chapter 1 1-5
Setting Up the Jukebox
Identifying Right-Side Panel Features
Ch
ap
ter
1
: Setti
n
g
u
p
th
e Disk
Driv
e
S
ettin
g
Up
th
e
Ju
kebo
x
The numbers below correspond to the numbers in Figure 1-1 on the previous
page
1 Active bus
indicator
Lit when the SCSI bus is active. There is an indicator
for each single-ended and each differential interface in
the jukebox.
2 SCSI interface
selection switch
Used to select either a single-ended or differential SCSI
interface on the SCSI interface board.
In 4- or 6-drive jukeboxes, there is one interface board.
In 10-drive jukeboxes, there are two interface boards,
designated Bus 1 and Bus 2. The interface selection
switch must be set individually for each board
3 SCSI ports Used for connecting SCSI cables to the interface board.
The interface board has two types of interface;
single-ended and differential. Each type of interface has
two ports
4 Power cord strain
relief clip
Used to route the power cord away from other
connectors and provide strain relief for the power cord
connection.
5 Product serial
number label
Needed for service calls. Write down your jukebox
serial number before you call your service
representative.
6 Access panel and
mounting screws
Panel that covers the interface and power connection
components. The panel is secured by two screws on the
lower corners. (See the following note.)
Continued on the next page
7 Cable access hole Used to pass SCSI and power cables through to the
inside of the jukebox.
8 Power switch The power switch is under the panel but can be operated
through the hole in the panel. Turns power ON and OFF
to the jukebox.
9 Power receptacle Receptacle for the jukebox power cord. Located on the
bottom of the power distribution assembly.