Connecting:4- or 6-drive jukebox, Removing the customer access panel, These screws may not have been replaced – HP Optical Jukeboxes User Manual

Page 21: Connecting a 4- or 6-drive jukebox -9, Removing the customer access panel -9, Connecting a 4- or 6-drive jukebox

Chapter 1

1-9

Setting Up the Jukebox

Connecting a 4- or 6-Drive Jukebox

Ch
ap
ter
1

: Setti

th
e Disk

Driv

ettin
g

th
e

kebo

Connecting a 4- or 6-Drive Jukebox

CAUTION

Make sure that all peripheral devices connected to the host computer have been
properly shut down. If the host computer is connected to a network, check with the
system administrator before switching off power.

Removing the Customer Access Panel

1. Switch off power to the host computer before you connect the jukebox

NOTE

The jukebox ships from the factory with two screws securing the bottom of the
customer access panel to the side of the jukebox. These screws are removed during
the process of unpacking and removing the jukebox from the shipping pallet.

These screws may not have been replaced.

It is a good idea to use the screws to secure the access panel to the jukebox since
they must be in place if the jukebox is ever reshipped.

If you have to replace these screws, they are 6/32 x .437.

2. Remove the customer access panel by pulling on the bottom of the panel and

then lifting it off (see Figure 1-1). (If screws are installed, use a flatblade
screwdriver or T-15 Torx driver.)