HP StoreFront Mobile Access Software - Manual (Page 25)

1. Open Windows Explorer to < install folder >\XF\XFMOBILEROOT\config . Do one
of the following:
• If an xf.cfg file is present, go to step 2.
• If an xf.cfg file is not present, create one by copying and pasting the xf.cfg template
file from \XF\config.
2. Open the \XFMOBILEROOT\config\xf.cfg file in a text editor.
3. To change the Communication port, edit the value in the httpPort line. If a # comment character
is at the start of the line, delete it.
4. To change the Security port, edit the value in httpsPort line. If a # comment character is at the
start of the line, delete it.
5. Save the edited xf.cfg file.
6. Restart the HP MIF for Mobile service for the changes to take effect. See Mobility Setup Tool
“configuration – restart command” (page 35) .
Changing HP Mobile Gateway ports
The HP Mobile Gateway configuration file is mg.cfg.
1.
Open Windows Explorer to < install folder >\MGROOT\config . Do one of the following:
• If an mg.cfg file is present, go to step 2.
• If an mg.cfg file is not present, create one by copying and pasting the mg.cfg template
file from \MG\config.
2. To change the Mobile Access server port, edit the value in the port line. If a # comment
character is at the start of the line, delete it.
3. To change the Server Configuration port, edit the value in internalPort line. If a # comment
character is at the start of the line, delete it.
4. Save the edited mg.cfg file.
5. Restart the HP Mobile Gateway service for the changes to take effect. See “configuration –
restart command” (page 35) .
Changing the HP 3PAR Content Provider port
The HP 3PAR Content Provider configuration file is 3PARMCS.cfg.
1.
Open Windows Explorer to< install folder >\MGROOT\config\3PARMCS.cfg . Do
one of the following:
• If a 3PARMCS.cfg file is present, go to step 2.
• If a 3PARMCS.cfg file is not present, create one by copying and pasting the 3PARMCS.cfg
template file from \3PARMCS.
2. To change the 3PAR Content Provider port, edit the value in the mobileTsPort line. If a #
comment character is at the start of the line, delete it.
3. Save the edited 3PARMCS.cfg file.
4. Restart the HP 3PAR Mobile Content Provider service for the changes to take effect. See the
Mobility Setup Tool
“3PARsetup – restart command” (page 32) .
Listen address
The HP StoreFront Mobile Access server listen address establishes the IP address for all web services
on the HP StoreFront Mobile Access server. Administrators can manage the listen address using
commands in the Mobility Setup Tool. See Mobility Setup Tool
“configuration – change listenAddress
command” (page 32) . This is typically done to specify the IP address to use on a multi-home server.
By default, the IP address of the physical or VM server is used as the listen address. The HP
StoreFront Mobile Access server software determines the IP address of the server as follows:
Listen address 25