HP XC System 3.x Software - Manual (Page 92)

The srun command handles both serial and parallel jobs.
The srun command has a significant number of options to control the execution of your
application closely. However, you can use it for a simple launch of a serial program, as
Example 9-1 shows.
Example 9-1 Simple Launch of a Serial Program
$ srun hostname n1
9.3.1 The srun Roles and Modes
The srun command submits jobs to run under SLURM management. The srun command can
perform many roles in launching and managing your job. The srun command operates in several
distinct usage modes to accommodate the roles it performs.
9.3.1.1 The srun Roles
The options of the srun command allow you control a SLURM job by:
•
Specifying the parallel environment for your job when you submit it, such as the number
of nodes to use, partition, distribution of processes among nodes, and maximum time.
• Controlling the behavior of your parallel job as it runs, such as by redirecting or labeling its
output, sending it signals, or specifying its reporting verbosity.
9.3.1.2 The srun Modes
The srun command has five distinct modes in which it can be used:
• Simple mode
• Batch mode
• Allocate mode
• Attach mode
• Batch (with LSF-HPC) mode
The SLURM Reference Manual describes the Simple, Batch, Allocate, and Attach modes.
You can submit a script to LSF-HPC that contains (simple) srun commands to execute parallel
jobs later. In this case, LSF-HPC takes the place of the srun -b option for indirect, across-machine
job-queue management.
9.3.2 Using the srun Command with HP-MPI
The srun command can be used as an option in an HP-MPI launch command. See Chapter
Chapter 5: Submitting Jobs for information about using srun with HP-MPI.
9.3.3 Using the srun Command with LSF-HPC
The srun command can be used in an LSF-HPC launch command. See Chapter Chapter 10:
Using LSF-HPC for information about using srun with LSF-HPC.
9.4 Monitoring Jobs with the squeue Command
The squeue command displays the queue of running and waiting jobs (or "job steps"), including
the JobID used for scancel), and the nodes assigned to each running job. It has a wide variety
of filtering, sorting, and formatting options. By default, it reports the running jobs in priority
order and then the pending jobs in priority order.
Example 9-2 reports on job 12345 and job 12346:
92 Using SLURM