HP Officejet Pro 8100 ePrinter - N811a N811d - Manual (Page 24)

3. Set the printer on top of the tray.
CAUTION: Be careful to keep your fingers and hands clear of the bottom of
the printer.
4. Connect the power cord and turn on the printer.
5. Enable Tray 2 in the printer driver. For more information, see Turn on accessories
in the printer driver.
To load Tray 2
1.
Pull the tray out of the printer by grasping under the front of the tray.
2. Insert the paper print-side down in the center of the tray. Make sure the stack of
paper aligns with the line on the width guide, and does not exceed the line
marking on the guide.
NOTE: Tray 2 can be loaded only with plain paper.
3. Slide the media guides in the tray to adjust them for the size that you have
loaded.
Chapter 1
20 Get started