HP ProLiant Support Pack - Manual (Page 15)

Deploying PSPs 15
NOTE: Ensure that each NIC has an IP address assigned. To get the IP address assigned to a
NIC, issue the dhclient command in the console, which enables the NIC interfaces and
retrieves an IP address. If a NIC does not have an IP address, HP SUM appears to hang on start
up.
o RHEL6 Console Mode:
NOTE: You cannot use an X console in either the x86 or x86_64 version. You must install the
base server with defaults and the following RPMs listed to run HP SUM in silent mode.
— lm_sensors-libs-3.1.1-10.el6..rpm
— net-snmp-libs-5.5-27.el6..rpm
— net-snmp-5.5.27.el6..rpm
— kernel-headers-2.6.32-71.el6..rpm
— redhat-rpm-config-9.0.3-25.el6.noarch.rpm
— kernel-devel-2.6.32-71.el6..rpm
— rpm-build-4.8.0-12.el6..rpm
— gcc-4.4.4-13.el6..rpm
o RHEL6 Graphical Mode:
NOTE: If you elect to install the XWindows support, then RHEL6 Graphical Mode applies to both
x86 and x86_64.
NOTE: The following items must be the 32-bit version even under x86_64 architecture as HP
SUM and several of the RPMs require 32-bit libraries installed.
— libuuid-2.17.2-6.el6.i686.rpm
— freetype-2.3.11-5.el6.i686.rpm
— libSM-1.1.0-7.1.el6.i686.rpm
— libICE-1.0.6-1.el6.i686.rpm
— libXi-1.3-3.el6.i686.rpm
— libX11-1.3-2.el6.i686.rpm
— libXext-1.1-3.el6.i686.rpm
— libxcb-1.5-1.el6.i686.rpm
— libXau-1.0.5-1.el6.i686.rpm
— libXrender-0.9.5-1.el6.i686.rpm
— libXrandr-1.3.0-4.el6.i686.rpm
— libXfixes-4.0.4-1.el6.i686.rpm
— libXcursor-1.1.10-2.el6.i686.rpm
— fontconfig-2.8.0-3.el6.i686.rpm
— expat-2.0.1-9.1.el6.i686.rpm
— expect-5.44.1.15-2.el6..rpm
— zlib-1.2.3-25.el6.i686.rpm