HP LaserJet M1005 Multifunction Printer series - Manual (Page 55)

Reducing or enlarging copies
The device can reduce copies to as little as 25% of the original size or enlarge copies to as much as
400% of the original size.
Reduction/enlargement settings
● Original=100%
● A4 > Ltr=94%
● Ltr > A4=97%
● Full page=91%
● 2 pages/sheet
● 4 pages/sheet
● Custom: 25-400%
NOTE: For information about using the 2 pages/sheet or 4 pages/sheet setting, see Copying multiple
pages on one sheet of paper on page 46 .
Adjusting the copy size
To reduce or enlarge copies for the current job
1. On the device control panel, press More Copy Settings .
2. Use the < or the > button to select Reduce/Enlarge, and then press Menu/Enter .
3. Use the < or the > button to select the size to which you would like to reduce or enlarge the copies
in this job.
NOTE: If you select Custom: 25-400%, use the < or the > button to adjust the percentage.
4. Press Start Copy to save the selection and immediately start the copy job, or press Menu/Enter to
save the selection without starting the job.
NOTE: The change in the setting remains active for about two minutes after the copy job has been
completed. During this time, Settings=Custom appears on the device control-panel display.
You must change the default media size in the media input tray to match the output size, or part of your
copy might be cut off.
To adjust the default copy size
NOTE: The default copy size is the size to which copies are normally reduced or enlarged. If you keep
the factory default size setting of Original=100%, all copies will be the same size as the original
document.
1. On the device control panel, press Menu/Enter .
2. Use the < or the > button to select Copy setup, and then press Menu/Enter .
3. Use the < or the > button to select Def. Reduce/Enlrg, and then press Menu/Enter .
4. Use the < or the > button to select the option for how you normally want to reduce or enlarge copies.
ENWW Reducing or enlarging copies 45