Scan problems, Solving scanned-image problems – HP LaserJet M1005 Multifunction Printer series User Manual
Page 105
Scan problems
Solving scanned-image problems
Problem
Cause
Solution
The scanned image is of
poor quality.
The original might be a second-
generation photo or picture.
●
To eliminate the patterns, try reducing the size of the
image after scanning.
●
Print the scanned image to see if the quality is better.
●
Verify that your resolution and color settings are
correct for the type of scan job that you are
performing. See
The image that appears on the screen
might not be an accurate
representation of the quality of the
scan.
●
Try adjusting your computer monitor settings to use
more colors (or levels of gray). Typically, you make
this adjustment by opening Display in Windows
Control Panel.
●
Try adjusting the resolution and color settings in the
scanner software. See
The original might have been loaded
incorrectly.
Make sure that you have loaded the original correctly on
the flatbed scanner. See
The scanner might be dirty.
Clean the scanner. See
The graphics settings might not be
suitable for the type of scan job that
you are performing.
Try changing the graphics settings. See
resolution and color on page 61
Part of the image did not
scan.
The original might have been loaded
incorrectly.
Make sure that the original is placed correctly on the
flatbed scanner.
A colored background might be
causing images in the foreground to
blend into the background.
Try adjusting the settings before you scan the original or
enhancing the image after you scan the original. See
Scanner resolution and color on page 61
The original is too small.
The minimum size that the flatbed scanner supports is 25
x 25 mm (1 x 1 inch).
The media size is incorrect.
In Scan settings, make sure that the input media size is
large enough for the document that you are scanning. See
Scanner resolution and color on page 61
The scan takes too long
The resolution or color level is set too
high.
Change the resolution and color level settings to the
correct settings for your job. See
.
The software is set to scan in color.
The system default is color, which takes longer to scan
even when scanning a monochrome original. If you
acquire an image through TWAIN or WIA, you can change
the settings so that the original scans in grayscale or
black-and-white. See the device software Help for details.
A print job or copy job was sent before
you tried to scan.
If someone sent a print job or copy job before you tried to
scan, the scan will start if the scanner is not busy.
However, because the device and scanner share memory,
the scan might be slower.
ENWW
Scan problems
95