HP Scitex FB700 Industrial Printer - Manual (Page 92)

Table A-5 Printer power specifications (continued)
Required power cord The printer can use any of the following 4.5 m (14.8 ft) power cords:
● USA: HP part number 8120–6903
● Europe: HP part number 8120–6899
● Cord without connector to electric outlet (for use with customer-
supplied connector): HP part number 8120–6895
Optional auxiliary power for ink system vacuum When configured as shipped, if the power cord to the printer is removed,
power to the ink system vacuum is removed. If the printer standby power
switch is switched off, but the power cord is not removed, power to the
vacuum is preserved. The ink system vacuum maintains the negative
pressure required for printing operation and prevents ink dripping from the
printheads when the printer is idle.
You can preserve power to the ink system vacuum during power outages
by connecting the supplied power cord (length: 137 cm (4.5 ft)) from the
auxiliary power connection (below the ink box racks) to one of the
following:
● Wall outlet — 100-240 VAC, 50/60 Hz, provides temporary power to
the vacuum system when it is necessary to remove power from the
printer for service.
● UPS — customer-supplied uninterruptable power supply, output
100-240 VAC, 50/60 Hz, minimum of 15 watts of power, provides
battery backup to the vacuum system in the event of a power failure.
UPS is connected to the electric wall outlet.
Environmental
Table A-6 Printer environmental specifications
Operating conditions Temperature: 20–30° C (68–85° F )
Relative Humidity: 20–80%, non-condensing (40–60% recommended to
avoid static electricity on synthetic media that occurs below 40%, and
buckling on paper-based media over 60%.)
Maximum operating altitude: 3000 m (10,000 ft)
Storage conditions Temperature: -34–49° C (-30–120° F)
Relative Humidity: 10–80%, non-condensing
86 Appendix A Specifications ENWW