HP Scitex FB700 Industrial Printer - Manual (Page 69)

Remove the old UV lamp bulb
NOTE: Wear cotton gloves to protect the reflector and replacement bulb from fingerprints which
would reduce bulb life and reflector efficiency.
1. Pull the spring-loaded clamp (A) from the side of the lamp reflector (B) as shown below.
Figure 9-5 Spring-loaded clamp
2. Loosen the two screws that hold the two reflectors together until the outside reflector can be
removed.
Figure 9-6 Reflector screws
3. The reflector screws are captive screws and are not meant to be fully removed. If you do fully
remove the screws, take care that the screws do not drop into the lamp housing.
NOTE: Do not bend any of the tabs on the reflectors.
ENWW Replace UV lamp bulb (500–1000 hours) 63