HP Scitex FB700 Industrial Printer - Manual (Page 17)

Work with the rigid media tables
Figure 2-1 Output (1) and input (2) tables
The printer includes a set of standard input and output tables for rigid media handling: one for the
input side of the printer, and one for the output side. These tables are assembled, installed and
leveled when the printer is installed. The tables are designed to be used only when the tabletop is in
the horizontal position and latched to the printer. The latches, see (1)
Figure 2-2 Table latches and
release cable on page 11 , are needed for safety, print quality, and to provide a ground path to
discharge the electrostatic charge from synthetic media.
The tabletop can be pivoted to a near-vertical position to save space during storage. After detaching
the tables from the printer, release the tabletop latches by pulling the release cable, see (2)
Figure
2-2 Table latches and release cable on page 11 , under the tabletop. To return the tabletop to its
operating position, pivot the table top down and press down firmly to engage the latches.
Figure 2-2 Table latches and release cable
Optional extension tables are also available as an accessory, When properly assembled and
attached to the ends of the standard tables, the extension tables enable safe and reliable handling of
large media sheets. During use, the extension tables must be latched to the standard tables for
ENWW Work with the rigid media tables 11