HP SAN Virtualization Services Platform - Manual (Page 60)

* indicates all Fibre Channel ports on the DPM.
Examples
Here is a sample output for port 1 on a system after running show port 1.
Port1:
WWPN: 5000-XXXX-XXXX-XX21
State: LINK-ESTABLISHED
Capability: ['FCP_INITIATOR']
Type -
Configured: FABRIC Actual: FABRIC
Speed - Configured: NEGOTIATE Actual: 4G
Class - Configured: ['THREE']
Max Frame Size (in bytes):
2048
License: YES
See also
“ Disable port command ” on page 24
“ Enable port command ” on page 29
“ Modify port command ” on page 38
“ Modify ports command ” on page 39
“ Reset port command ” on page 44
“ Show ports command ” on page 60
Show ports
command
Returns diagnostic and status information for all ports on the DPM. See the sample output in the
Examples section below for more information.
Syntax
show ports
Keywords
ports
Indicates all Fibre Channel ports on the DPM.
Examples
Here is a sample output after running show ports.
Num State Cap. Type(conf/act) Speed Mtu
0 ESTABLISHED TARG FABRIC/FABRIC NEG/4G 2048
1 ESTABLISHED INIT FABRIC/FABRIC NEG/4G 2048
2 ESTABLISHED TARG FABRIC/FABRIC NEG/4G 2048
3 ESTABLISHED INIT FABRIC/FABRIC NEG/4G 2048
4 NO-SIGNAL TARG FABRIC/UNSET NEG/UND 2048
5 NO-SIGNAL INIT FABRIC/UNSET NEG/UND 2048
6 NO-SIGNAL TARG FABRIC/UNSET NEG/UND 2048
7 NO-SIGNAL INIT FABRIC/UNSET NEG/UND 2048
8 NO-SIGNAL TARG FABRIC/UNSET NEG/UND 2048
9 NO-SIGNAL INIT FABRIC/UNSET NEG/UND 2048
CLI commands 60