HP Integrity BL870c i2 Server-Blade - Manual (Page 80)

Command line 80
Name RFC Description
ExceededDiscards by this port due to an excessive
size. It is incremented by both
transparent and source route
bridges.
rfc1213_Dot1dPortInDiscard
s
1493 Count of valid frames received
which were discarded (i.e.,
filtered) by the Forwarding
Process.
rfc1213_Dot1dTpPortInFram
es 1493 The number of frames that have
been received by his port from its
segment. Note that a frame
received on the interface
corresponding to this port is only
counted by this object if and only
if it is for a protocol being
processed by the local bridging
function, including bridge
management frames.
rfc1757_StatsBroadcastPkts 1757 The number of good packets
received during this sampling
interval that were directed to the
broadcast address
rfc1757_StatsCRCAlignError
s
1757 The total number of packets
received that had a length
(excluding framing bits, but
including FCS octets) of between
64 and 1518 octets, inclusive, but
but had either a bad Frame Check
Sequence (FCS) with an integral
number of octets (FCS Error) or a
bad FCS with a non-integral
number of octets (Alignment
Error).
rfc1757_StatsCollisions 1757 The best estimate of the total
number of collisions n this Ethernet
segment. The value returned will
depend on the location of the
RMON probe. Section 8.2.1.3
(10BASE-5) and section 10.3.1.3
(10BASE-2) of IEEE standard
802.3 states that a station must
detect a collision, in the receive
mode, if three or more stations are
transmitting simultaneously. A
repeater port must detect a
collision when two or more
stations are transmitting
simultaneously. Thus a probe
placed on a repeater port could
record more collisions than a
probe connected to a station on
the same segment would.