HP NonStop G-Series - Manual (Page 219)

Device State
Value Meaning
Aborting Processing is terminating.
AC Power Loss The device is currently not powered by either AC or UPS.
Defined State is defined by the NonStop OS.
Degraded Performance is degraded.
Diagnose A diagnostic test is running on the component.
Initializing Processing is starting up.
Not Available State is not available to OSM.
Not Configured The component is not configured.
Not Installed The component is not installed.
OK Component is accessible.
On The device is powered on
Started The component is running.
Starting Processing is starting up.
Stopped Processing has been terminated.
Stopping Processing is being terminated.
Unknown Component is not responding.
Enabled State
Value Meaning
Disabled
The component is present but not operational, possibly because the Disable action was
performed.
Enabled The component is operational.
Fault
A problem was detected. The component might be functioning below standard or not
responding. Inspect the component.
Off The component is not functional.
On The component is functional.
Unknown State is unknown; component might not be responding.
Group Type
A unique number in the system that identifies this group. Group Type is displayed in a window on
the front door of the enclosure.
Depending on your system configuration and topology, these are the possible group numbers for
processor enclosures and I/O enclosures:
Processor Enclosures I/O Enclosures
01 11, 12, 13
02 21, 22, 23