HP NonStop G-Series - Manual (Page 174)

Replace
Displays the procedure for replacing the power supply.
Power Supply (IOAM)
Attributes
Actions
Supplies power to the IOAM . There are two IOAM power supply units in each IOAM.
For information on how to replace an individual Power Supply, see the Support and Service >
Service Procedures collection in NTL.
Note: If a ServerNet switch board is not present, the IOAM power supplies will not appear in
OSM.
Location in OSM Tree: System > Group > IOAM Enclosure > IOAM > Power Supply
Example: Power Supply (13.2.15)
Attributes
IOAM Power Supply
Service State
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.
Values
Physical
Part Number
The part number of the component that was assigned in manufacturing. Use
part numbers for identifying and ordering parts.
Manufacturer Identifies the manufacturer of the component.
Vendor Model Number
A code that identifies the generation of the component. Hardware revision
codes are used for tracking components.
Vendor Part Number The part number of the component assigned by the vendor.
Vendor Revision
A code that identifies the generation of the component provided by its
supplier.
Vendor Serial Number
The serial number of the component assigned to it by the supplier of the
component.
Logical
Device State The state of the component as known to the operating system on the server. Values