Table row, Run istat test displays (this initializes the elem, Run istat test – HP Surestore 320ex Optical Jukebox User Manual
Page 72: Power cycle the jukebox, Run the, If steps above do not result in a ready display, Can't write to the disk, Check the host file system access permissions, Eject the disk and check that the write-protect, Check your application software
3-38
Chapter 3
Operating the Jukebox
Troubleshooting
RUN ISTAT TEST
displays (this initializes
the element status)
•
Power cycle the jukebox.*
•
Run the
INIT ELEM
STATUS
test under
the
TEST *
menu
•
If steps above do not result in a READY display,
call your service representative.
Can't write to the disk.
•
Check the host file system access permissions.
•
Eject the disk and check that the write-protect
tab on each side of the disk is in the
write-enabled position.
•
Check your application software.
•
If steps above are unsuccessful, call your service
representative.
*Ensure that the SCSI bus is inactive before removing power to the jukebox.
Removing power to a device on an active SCSI bus can cause data loss and/or
problems with the SCSI interface.
Problem
What to do